- Concrete Substrate Profile – ICRI Concrete Surface Profile CSP 2 to CSP 4
- Primer – 8202 CrownPrime™ Pigmented 200 sq. ft. per gal (18.6 sq. m. per 3.79 lt.) 8 mils (0.2 mm). Complementary or contrasting pigment colors are recommended.
- Body Coat – 8328 CrownShield® and CrownMetallic™ SP710 Pigments place at 27 to 53 sq. ft. per gal (2.5 to 4.6 sq. m. per 3.79 lt.) 30 to 60 mils (0.76 to 1.5 mm). Note: For best results pre-mix all A Components and CrownMetallic™ and let stand, remix prior to mixing the A & B Components together to reduce pigment satellites.
- Top Coat – 8175 CrownPro™ 160 sq. ft. per gal (14.9 sq. m. per 3.79 lt.) 10 mils (0.25 mm)
SYSTEMS
Epoxy Metallic
Crown Metallic™ 8328 CrownShield® Epoxy and Metallic Pigments for Decorative Flooring System, which is placed at a Nominal 30 Mils to 60 Mils (0.76 to 1.5 mm).
System Build
CrownMetallic™ 8328 CrownShield® Epoxy and Metallic Pigmentsfor Decorative Flooring System. The system is placed at a nominal 30 mils to 60 mils (0.76 to 1.5 mm). It is recommended to place the floor at 60 mils (1.5 mm) to create a three-dimensional decorative look. It can be placedwith or without an optional sprinkling of skid resistant aluminum oxide aggregate. The aluminum oxide will change the reflective index. It can be applied directly over Crown Polymers moisture mitigation primer when it is required. It is available with an optional integral cove base binder and natural quartz aggregate. It is VOC Compliant in all states and provinces in North America.
- Aircraft Hangars and Maintenance Floors
- Automotive Shopsand MechanicsFloors
- Commercial Retail Floors
- Garage and Residential Floors
- Hospital and Health Care Facility Floors
- Laboratories and Research Floors
- Pharmaceutical Floors
- Schools and Universities Floors
- Warehouse Floors
- Note: Use appropriateFinish Coat
Note: Use appropriate Finish Coat
- Complies with USDA, FDA, Food Safety Modernization Act. See Crown Polymers Technical Bulletin:3 Food and Beverage Compliance.
- Slip Resistance (ADA) See Crown Polymers Technical Bulletin:4 Coefficient of Friction.
- LEED® and Green Seal® requirements. See Crown Polymers Technical Bulletin: 5 LEED and Green Seal Information.
- VOC and EPA Compliant, and low odor during installation. Cures to an inert finish. See Crown Polymers Technical Bulletin: 2 VOC Compliance.
- All components are VOC Compliant in all states and provinces in North America.
- Strong and Tough Floor.
- Excellent Chemical and Abrasion Resistance
- Designed for new floors and for resurfacing old floors
© 2023 Crown Polymers Corp., All Right Reserved